The content of the article comes from the Internet.At the time of the product of the plastic material such as PET bottle embryo, the temperature is a major factor on the impact of the quality, then what is the impact on the quality of the time when it is? Let's take a look at it.

The temperature is too high: in the process of processing PET bottle embryos, in general, if the temperature of the machining is high, it is a serious influence on the overall quality, which may result in problems Many, it seems to be thin, transparency is high, and the time division is not strong, and it is the form of the bottle blank exhibits a soft nature, and PETG containers Suppliers it is unreliable.

The temperature is a place with a large amount of mass impact on PET bottle embryos, and only needs to grasp the problem of temperature, and the quality guarantee is certain that there is no problem. The temperature lack: a more embarrassing temperature when the temperature is lacking, in this case, the bottle blank produced in the case is that we have no steaming in the steamed steamed bun, and it is more small and twisted. Transparency is also very poor, and the time division is not used directly, the bottle wall is a relatively thick, but it is not how strong.

Servo motor drive plasticize; single cylinder injection, improve the stability of the injection process Sex; use direct feed tube design; the closure of pneumatic control material is closed; temperature control detection, independent heating, and more satisfied with bottle embryo process requirements.

The advantages of the bottle blank needle, the design of the double straight wire guide, smooth operation; closed-loop control of the injection rate improves the accuracy of the injection.

Megosztás a facebookon